Hi, Need help to solve this : Mechanism is active (turning saw, laser enable, canons, for exemple). It stops suddenly. Then, I want it restarts and go on after X seconds. Wich variable is needed for doing this ? Thanks a lot !
Assuming you know what event triggers the stop and when, isn't it just a case of putting a delay event to X seconds after it stops?
Of course. But put a start, then put a stop, then put a start again. I wondered if a variable could guide this cycle and attached whith only one toggle event ? Edit: I try tro understand variables I don't usually use. It becomes complicated.
Sure. Just use the IF event (A>B) and initialize (put in) a variable which has a value of zero. Then the first time it goes to True condition which is the toggle event and increases the variable by 1. Set a delay after it and forward it back to the IF event. Then when this happens, the variable is now 1 so when the IF condition is set to 0 or below, it can now go to the false condition which is nothing and thus terminates the system (program).
Ouch ! Me again, sorry. Complicated. I think I'm wrong with connections. Right after the (A>B), do these two variables needed ? (=1) (123) ? Edit : Succed. It works.
Great! Glad you had that figured out. And glad you found that using the On/Off (Also known as a boolean variable) variable is also neater. Now go make some contraptions and blow us away!